离散求和法应用于空气弹簧ANSYS多步分析

李锋祥; 丁玉梅; 杨卫民

北京化工大学学报(自然科学版) ›› 2007, Vol. 34 ›› Issue (1) : 58-61.

PDF(290 KB)
欢迎访问北京化工大学学报(自然科学版),今天是 2025年5月10日 星期六
Email Alert  RSS
PDF(290 KB)
北京化工大学学报(自然科学版) ›› 2007, Vol. 34 ›› Issue (1) : 58-61.
论文

离散求和法应用于空气弹簧ANSYS多步分析

  • 李锋祥; 丁玉梅; 杨卫民
作者信息 +

Apply scatter sum method to multiple steps analysis of an air spring by ANSYS

  • Li Fengxiang;Ding Yumei;Yang Weimin
Author information +
文章历史 +

摘要

列举了空气弹簧ANSYS仿真过程中存在的一些问题和难点。介绍了EQ6111空气弹簧的结构和材料特点,并针对性地建立了空气弹簧的有限元模型。针对空气弹簧分析过程中所存在的气压载荷问题,采取了多步分析的思路。在此思路的基础之上,采用离散求和法编写胶囊容积计算宏,应用于空气弹簧的垂向和横向静态力学性能分析,并将分析结果与试验结果和前人分析结果进行了比较,取得了较高的模拟分析精度,并且大大提高了仿真过程的连续性和可控制性。

Abstract

An experimental study of heat transfer characteristics in a flattened copperwater mini-axial grooved heat pipe (AGHP) using a round AGHP with an outer diameter of 6mm and length of 210mm as the base case is reported. This AGHP was subsequently flattened to heights of 3.5, 3, 2.5 and 2mm. The temperature distribution along the axial distance, maximum heat transfer rate (MHTR), thermal resistance and evaporation heat transfer coefficient were experimentally determined for both AGHP and flattened AGHPs with different flattening height at several saturated vapor temperatures. The MHTR was found to decrease by 75% when the AGHP was flattened from a height of 6mm to 2mm. The thermal resistance was 0.08℃/W for both the round AGHP and flattened AGHP when the flattening height was greater than 2.5mm. When the AGHP was flattened to a height of 2mm, a significantly higher thermal resistance was observed. The evaporation heat transfer coefficient at the same saturated vapor temperature increased as the AGHP was flattened from 6mm to 3.5mm. However, when the AGHP was flattened in the range 3.5mm to 2mm, the evaporation heat transfer coefficient decreased.

引用本文

导出引用
李锋祥; 丁玉梅; 杨卫民. 离散求和法应用于空气弹簧ANSYS多步分析[J]. 北京化工大学学报(自然科学版), 2007, 34(1): 58-61
Li Fengxiang;Ding Yumei;Yang Weimin. Apply scatter sum method to multiple steps analysis of an air spring by ANSYS[J]. Journal of Beijing University of Chemical Technology, 2007, 34(1): 58-61

参考文献

[1]楼京俊, 朱石坚. 长方体形空气弹簧刚度计算[J]. 噪声与振动控制, 2001, 21(4):22-26.
[2]TOYOFUKU K, YAMADA C, KAGAWA T, et al. Study on dynamic characteristi
c analysis of air spring with auxiliary chamber[J]. JSAE Review, 1999(20): 349-355.
[3]OUYANG Qing, SHI Yin. The non-linear mechanical properties of an air apr
ing[J]. Mechanical Systems and Signal Processing, 2003(17): 705-711.
[4]叶先磊, 史亚杰. ANSYS工程分析软件应用实例[M]. 北京: 清华
大学出版社, 2003.
[5]黄文虎, 陈滨, 王照林. 一般力学(动力学、振动与控制)最新进展[M]. 北京:
科学出版社, 1994.
[6]赵洪伦, 张广世. 高速客车空气弹簧非线性横向刚度特性研究[J]. 铁道学报, 19
99, 21(6): 30-33.
[7]吴善跃, 黄映云. 空气弹簧刚度的有限元分析方法[J]. 海军工程大学学
报, 2001, 13(6):94-98.
[8]杨卫民, 陈灿辉, 陈亚玲, 任彦莎. 汽车减振用空气弹簧的有限元分析[J]. 北京
化工大学学报, 2004, 31(3): 105-109.
[9]任彦莎, 杨卫民. 汽车用空气弹簧横向刚度的静态有限元分析[J]. 北京
化工大学学报, 2005, 32(3): 95-98.

PDF(290 KB)

3146

Accesses

0

Citation

Detail

段落导航
相关文章

/