以未表面处理的PAN基高模碳纤维(HMCF)为工作电极，分别用NH4H2PO4`NH4HCO3和KOH为电解质，进行循环伏安多重扫描，以研究HMCF在不同电解质中的电化学反应行为以及电解质的氧化能力。同时采用连续恒流阳极氧化的方法对HMCF进行表面处理，验证循环伏安法得到的结论。通过联碱滴定、SEM等方法表征处理前后纤维表面官能团、表面形貌的变化；处理前后纤维与环氧树脂界面粘接性能的变化通过层间剪切强度(ILSS)表征。循环伏安结果显示：在NH4H2PO4溶液中扫描时氧化反应峰值电流最高，表明纤维表面生成的官能团最多;在KOH溶液中扫描时平台电流最高，表明纤维表面粗糙度提高幅度最大。联碱滴定结果表明NH4H2PO4溶液处理后纤维表面官能团含量提高最多;SEM结果显示KOH溶液处理后纤维表面粗糙度增加最明显；这两点验证了循环伏安多重扫描的结果。用NH4H2PO4`KOH处理后的纤维与环氧树脂ILSS达到75MPa、60MPa，分别提高240%和170%。
Abstract
Untreated PAN-based high-modulus carbon fibers (HMCF) were used as an anode and electrochemically oxidized by multi-scan cyclic voltammetry in NH4H2PO4, NH4HCO3and KOH. The electrochemical reactivity in different electrolytes
and the ability of each electrolyte to oxidize HMCF were investigated. The carbon fibers were then treated by the method of continuous constant current anodic oxidation which confirmed the conclusions of cyclic voltammetry. The chemical titration method and SEM were used to study the changes in number of functional groups and surface morphology of the carbon fibers. The adhesive properties of the carbon fiber/epoxy resin composites were characterized in terms of their interlaminar shear strength (ILSS). Cyclic voltammetry indicated that the oxidation peak current in NH4H2PO4 solution is the highest, showing that the number of
functional groups on the fiber surface is the highest in this electrolyte. The background current in KOH is higher than those in other electrolytes, revealing that the roughness of the fiber surface has undergone the greatest change. The titration results indicate that the content of surface functional groups in the fiber treated in NH4H2PO4is larger than in those treated in the other electrolytes. SEM results demonstrate that the surface roughness of the fiber treated in KOH is the largest, which is consistent with the cyclic voltammetry data. The ILSS offiber/epoxy resin composites, in which the fibers were treated in NH4H2PO4 and KOH, were 75MPa and 60MPa, respectively, corresponding to increases of 240% and 170% relative to the untreated fiber.
{{custom_sec.title}}
{{custom_sec.title}}
{{custom_sec.content}}
参考文献
［1］ParkJ M, Lee S I, Kim K W, et al. Interfacial aspects of electrodeposited conductive fibers/epoxy composites using electro-micromechanical technique and nondestructive evaluation［J］. Journal of Colloid and Interface Science, 2001,237: 89-90.
［2］BasovaY V, Hatori H, Yamada Y, et al. Effect of oxidation-reduction
urface treatment on the electrochemical behavior of PAN-based carbon fibers［J］. Electrochemistry Communications, 1999, 1: 540-544.
［3］YueZ R, Jiang W, Wang L, et al. Surface characterization of electrochemically oxidized carbon fibers［J］. Carbon, 1999, 37: 1785-1796.
［4］郭云霞, 刘杰, 梁节英. 电化学改性对PAN基碳纤维表面状态的影响［J］. 复合材料学报, 2005, 22(3): 50-53.
Guo Y X, Liu J, Liang J Y. Effect of electrochemical modification on the surface state of PAN-based carbon fibers［J］. Acta Materiae Compositae Sinica， 2005，22(3): 50-53. (in Chinese)
［5］曹海琳，黄玉东，张志谦，等. 碳纤维阳极氧化法处理对复合材料界面性能的影响［J］. 材料工程，2000(4):16-18.
Cao H L，Huang Y D，Zhang Z Q，et al. The effect of anodic oxidation treatment on interfacial properties of composites ［J］. Material Engineering，2000(4):16-18. (in Chinese)
［6］刘鸿鹏, 吕春祥, 李永红, 等. 电化学表面处理PAN基炭纤维的表面性能研究［J］. 新型炭材料, 2005, 20(1): 40-42.
Liu H P, Lv C X, Li Y H, et al. Surface properties of electrochemically oxidized PAN-based carbon fibers［J］. New Carbon Materials, 2005, 20(1): 40-42. (in Chinese)
［7］RyuS K, Park B J, Park S J. XPS analysis of carbon fiber surfaces-anodized and interfacial effects in fiber-epoxy composites［J］. Journal of Colloid and Interface Science, 1999, 215: 167-169.
［8］侯永平，王浩静，李东风. PAN基高模碳纤维阳极氧化的表面处理［J］. 化工进展，2007，26(4):559-562.
Hou Y P，Wang H J，Li D F. Anodic oxidation of PAN based high modulus carbon fiber［J］. Chemical Industry and Engineering Progress，2007，26(4):559-562. (in Chinese)
［9］NeffeS. Effect of anodic oxidation of PANbased carbon fibers on the morphological changes of their surfaces［J］. Carbon, 1987, 25: 761-767.
［10］BismarckA, Kumru M E, Springer J, et al. Surface properties of PAN-based carbon fibers tuned by anodic oxidation in different alkaline electrolyte
systems［J］. Applied Surface Science, 1999, 37: 143-48.
［11］曹海琳, 黄玉东, 张志谦. H3PO4溶液中碳纤维表面电化学改性机理研究［J］. 航空材料学报, 2004, 24(3): 33-34.
Cao H L, Huang Y D, Zhang Z Q. Study on the mechanisms of electrochemical surface treatment of carbon fibers in H3PO4 solution［J］. Journal of Aeronautical Materials, 2004, 24(3): 33-34. (in Chinese)
{{custom_fnGroup.title_cn}}
脚注
{{custom_fn.content}}
PDF(1412 KB)
